Shopping Cart

No products in the cart.

2015-2020 WRX 6-Speed Manual Carbon Fiber Driveshaft

The 1-piece driveshaft for the 2015-2020 Subaru WRX is a complete 2.75″ Carbon Fiber shaft. The 1-piece carbon shaft features larger, replaceable u-joints and can handle about 850WHP and 180 MPH. We had the tubing custom wound with a high modulus fiber to ensure the strength while making it small enough to clear everything under the car. All of the factory shields, plates and covers can be used without any alteration to the car at all. Not only will the car feel more responsive but it will also make a noticeable difference on the noise level in the car. By removing the factory 2-piece shaft and installing a single shaft, the car will feel more responsive due to the lighter weight of the shaft and also the fact that the hanger bearing is not moving up and down during acceleration.

Differential flange mounting holes must be drilled to accept 10mm bolts

Available for most popular motor/trans combinations, if you don’t see yours listed, custom shafts are also available.

Special Note: Clearance is required near the rear differential/tunnel area.

Eeldatav tarneaeg 14-30 päeva
SKU: 610264 Category:

The 1-piece driveshaft for the 2015-2020 Subaru WRX is a complete 2.75″ Carbon Fiber shaft. The 1-piece carbon shaft features larger, replaceable u-joints and can handle about 850WHP and 180 MPH. We had the tubing custom wound with a high modulus fiber to ensure the strength while making it small enough to clear everything under the car. All of the factory shields, plates and covers can be used without any alteration to the car at all. Not only will the car feel more responsive but it will also make a noticeable difference on the noise level in the car. By removing the factory 2-piece shaft and installing a single shaft, the car will feel more responsive due to the lighter weight of the shaft and also the fact that the hanger bearing is not moving up and down during acceleration.

Differential flange mounting holes must be drilled to accept 10mm bolts

Available for most popular motor/trans combinations, if you don’t see yours listed, custom shafts are also available.

Special Note: Clearance is required near the rear differential/tunnel area.